SMOK is a respected brand for vaping devices, and they have a large selection of different ones you can use. They have devices suitable for all types of vapers as their Nord X kit can cater to direct-to-lung (DTL) and mouth-to-lung (MTL), depending on the coils you use. Whether you are new to vaping or are an experienced vaper, you will need to set up and configure your device before using it to ensure you have a pleasurable vaping experience. Below are some tips and advice to help you get up and running and start enjoying your new SMOK vaping device.

Opening Your Nord X Kit

When you have purchased your SMOK Nord X Pod kit, and it has arrived, you will want to open the box and check that the contents are all there. Below is everything that you should see in your kit when you open it.

  • 1 x SMOK Nord X vaping device
  • 1 x USB Cable for charging
  • 1 x NORD X RPM pod
  • 1 x NORD X RPM2 pod
  • 1 x User Manual

When you have opened your kit and checked everything is there, you will want to ensure your battery is fully charged, so put this onto charge until the battery is full. You will also need to get your device ready so that you can use it once the battery is charged.

Deciding Which Configuration To Use

Before inserting the coil into your ne device, you will need to consider what coil to use, depending on your preference. As mentioned above, this device can be used as either an MTL device, or a DTL one, and the difference is below:

Direct-To-Lung (DTL): With a DTL device you draw the vape smoke directly into your lungs.

Mouth-To-Lung (MTL): With an MTL device you first draw the vape smoke into your mouth, before taking it into the lungs.

There are two coils included in your kit, but these are both DTL ones, so if you want to use the Nord X kit as an MTL device, you will need to purchase additional coils. The coils you get with the device allow you to use it as a sub-ohm vape, so you can use e-liquid with a higher vegetable glycerine ratio, and you can start cloud chasing. Once you have decided which coils to use, it is time to start putting everything together.

Getting Your Vape Ready To Use

You will need to read the instructions so you know how to put everything together, and once your battery is fully charged, you can begin. You will need to prime your coils by adding some vape juice to them and allowing it to soak in, and you can then insert them into the device. Insert the battery and then fill the tank with your e-liquid and turn the device on by pressing the power button rapidly five times. You are also set to go and take your first drag from your new SMOK Nord device and help ensure you do not go back to smoking cigarettes again.